Nice HOPP articulated-arm operator kit for double-leaf gates, up to 4.8 m, up to 2 × 160 kg, 24 V

Nice HOPP is an articulated arm operator for swing gates with wide concrete or masonry pillars. The distance from the pillar edge to the leaf pivot axis can be up to 25 cm. The kit is for a double swing gate with a total width of up to 4.8 m. Each leaf can be up to 2.4 m wide at a weight of up to 160 kg, or weigh up to 250 kg at a width of up to 1.5 m. The 24 V DC motors handle 35 cycles per hour.

Functions

• the HO7124 operator has a control unit and an OXI radio receiver, the second HO7224 operator has no control unit,
• self-learning of stop positions, slowdown points and leaf delay,
• photocells and control devices are connected with two wires via the BlueBus system,
• ready for the Nice PS124 backup battery.

Things to consider before installation

• Stops – the end stops are set in the operator. We recommend a ground stop for closing; if the gate does not have one, you can also set the closing end stop in the operator.
• Installation dimensions – determine dimension A from the chart in the manual according to dimension B and the opening angle.
• Environment – protection rating IP54, operation at −20 to +55 °C.

For a single swing gate there is Nice HOPP for 1 leaf; you will find other types in the Articulated arm operators category. We install the operator in the Košice and Prešov regions; see the Gate operators with installation page.