The Came FAST FA70230CB is an irreversible operator with an articulated arm for swing gates of family and apartment houses. It is especially suitable where the posts are wide or brick-built and a linear operator would not fit. According to the Came manual, a leaf 1 m long can weigh up to 300 kg, and at a length of 2.3 m up to 200 kg. It is the operator alone without accessories – for example as a replacement for a damaged operator or for building your own kit.
Control electronics in the operator
- ZF1N board – built in under the operator cover; no separate box for the electronics is needed.
- Settings – with the trimmers you set the automatic closing time from 0 to 120 s, the operating time from 15 to 55 s and the delay of the second leaf. DIP switches turn on automatic closing and select the step-by-step mode.
- Outputs – 230 V flashing light up to 25 W, 24 V open-gate indicator up to 3 W and 24 V AC accessory power up to 20 W.
- Remote control – a plug-in receiver card is required, for example the Came AF43S for TOP, TAM and TWIN remote controls at 433.92 MHz.
Before installation
- End positions – set with the cams of the limit switches in the operator. If the gate has no stops on the ground, use the mechanical stops from the package.
- Opening angle – 90° or 110° according to the installation dimensions A and B in the manual.
- Electric lock – Came always recommends one for swing gates, for example the Came LOCK81 lock.
- Safety – photocells, for example the Came DIR10, are connected directly to the terminals of the board.
- Duty cycle – the 230 V AC motor with a 30 % duty cycle is intended for a family house, not for a busy entrance.
Ready-made kits with photocells and a remote control are the Came FAST for 1 leaf and Came FAST for 2 leaves. You will find a replacement board as the Came ZF1N. In the Košice and Prešov regions we install the operator; more on the page Gate operators with installation.
