Hörmann magnetic sensor with contact for LineaMatic

The Hörmann LineaMatic operator recognises the gate's closed position with a magnetic contact. This consists of a sensor in the operator housing and a holder with a magnet on the gate. When the magnet comes within 20 mm of the sensor, the operator stops the gate. If the sensor fails, the operator does not recognise the end position and the gate may travel further, which can damage both the gate and the operator.

Replacement procedure

1. Disconnect the operator from the mains and open the operator cover.
2. Unscrew the circuit board holder and carefully push the old sensor out of it.
3. On the board, release the sensor wires from the REED terminal and connect the new sensor.
4. Put the sensor back into the holder, screw the holder on and close the cover.
5. Finish the repair with a function test.

Magnet holder

For operators from 03/2017 there is the LineaMatic Series 2 magnet holder; for older ones the holder up to 02/2017.

Send questions to eshop@saver.sk. In the Košice and Prešov regions we carry out repairs as part of our service.