Hörmann magnetic limit switch for LineaMatic, operators from 03/2017

The Hörmann LineaMatic sliding gate operator detects the gate's closed position with a magnetic contact. The sensor is in the operator housing; the counterpart with the magnet sits on a plastic holder attached to the gate. When the magnet comes within 20 mm of the sensor, the operator stops. The contact works without touching and therefore without wear.

When to replace the holder

The plastic holder is permanently outdoors. UV radiation and temperature fluctuations gradually make it brittle and the magnet may break off. The operator then does not recognise the closed position and the gate may travel past the end position. Replace a damaged holder as soon as possible.

What to bear in mind

• Operator age – the part is only for LineaMatic Series 2 (manufactured from 03/2017). For an older operator choose the holder for LineaMatic up to 02/2017.
• Installation – position the magnet with an offset of approx. 20 mm to the reed contact in the operator. Moving the holder changes the closed position of the gate.
• Sensor – if the sensor in the operator does not work, order the LineaMatic magnetic sensor.

If you are not sure of the operator type, send us a photo of the rating plate to eshop@saver.sk. In the Košice and Prešov regions we carry out repairs as part of our service.