Nice SNA1R10 control unit for Spin garage door operator

The Nice SNA1R10 is a control board for Nice Spin 10 and 11 garage door operators. Use it when the original control board fails. This is the newer version with a Bus T4 connector, through which you can conveniently set up the operator with the Nice O-View programmer. The board controls a 24 V DC motor.

What to bear in mind before ordering

• Operator type – compare the designation with the original board. This board does not replace the older SNA1/A version.
• Receiver – the board is supplied without the 433 MHz rolling-code radio receiver.
• Other Spin operators – for the Spin 23 there is the Nice SNA20R10, for the Spin 20, 21 and 22 the Nice SNA2.

Safety during replacement

Read the installation manual before replacing the board. Disconnect the operator from the mains first. Do not handle the board or connect anything to it while it is live.

If you are not sure, send us a photo of the board and the operator rating plate to eshop@saver.sk. In the Košice and Prešov regions we replace boards as part of our service.