Hörmann drive pulley holder with pulley for FS 10 rail

The holder with the drive pulley sits at the rear end of the FS 10 guide rail, on the operator head side. The operator shaft drives the toothed belt via the pulley. The tensioning unit is at the opposite, front end of the rail. A cracked holder or a worn pulley can be replaced separately; there is no need to replace the whole rail.

Which rails it fits

The part fits FS 10 rails with toothed belt manufactured from 1/8/2005, for example the FS 10 K. If you cannot identify the rail type, send a photo to eshop@saver.sk.

Installation

1. Disconnect the operator from the mains and use the emergency release to disconnect the door from the rail carriage.
2. Insert the belt into the holder first, then into the belt coupling.
3. Under belt tension, the holder slips into the rail. Pull it in, for example with a clamp, until the holes line up, and screw it in place.

When replacing it, also check the toothed belt and the tensioning pulley. We carry out repairs in the Košice and Prešov regions, see the Service page.